Danger Den Single 5 1/4" Bay Reservoir

Specs:

Laser Cut Cast Acrylic Material
3/8" Thick Acrylic Side and Back Pieces
Water-tight seals and pressure-leak tested
Fits in One (1) 5 1/4 Drive Bay
Uses HIGH FLOW FITTINGS
One (1) inlet and One (1) outlet fitting for higher reliability
Two (2) Pre-Drilled 5mm LED Holes
Easy to install/Refill Center divider to eliminate air bubbles
4 Fan Mounting Screws
Contoured edges and corners - injury free install

Installation:

Slide the Bay-Res reservoir into one 5 1/4 drive bay. Use the supplied screws to mount it into place. Connect the tubing. Note: Always leak-test equipment for at least 24 hours before installing in case.